Perl Cookbook

Perl CookbookSearch this book
Previous: 9.2. Deleting a FileChapter 9
Directories
Next: 9.4. Recognizing Two Names for the Same File
 

9.3. Copying or Moving a File

Problem

You need to copy a file, but Perl has no built-in copy command.

Solution

Use the copy function from the standard File::Copy module:

use File::Copy;
copy($oldfile, $newfile);

You can do it by hand:

open(IN,  "< $oldfile")                     or die "can't open $oldfile: $!";
open(OUT, "> $newfile")                     or die "can't open $newfile: $!";

$blksize = (stat IN)[11] || 16384;          # preferred block size?
while ($len = sysread IN, $buf, $blksize) {
    if (!defined $len) {
        next if $! =~ /^Interrupted/;       # ^Z and fg
        die "System read error: $!\n";
    }
    $offset = 0;
    while ($len) {          # Handle partial writes.
        defined($written = syswrite OUT, $buf, $len, $offset)
            or die "System write error: $!\n";
        $len    -= $written;
        $offset += $written;
    };
}

close(IN);
close(OUT);

Or you can call your system's copy program:

system("cp $oldfile $newfile");       # unix
system("copy $oldfile $newfile");     # dos, vms

Discussion

The File::Copy module provides copy and move functions. These are more convenient than resorting to low-level I/O calls and more portable than calling system. move works across file-system boundaries; the standard Perl built-in rename (usually) does not.

use File::Copy;

copy("datafile.dat", "datafile.bak")
    or die "copy failed: $!";

move("datafile.new", "datafile.dat")
    or die "move failed: $!";

Because these functions return only a simple success status, you can't easily tell which file prevented the copy or move from being done. Copying the files manually lets you pinpoint which files didn't copy, but it fills your program with complex sysreads and syswrites.

See Also

Documentation for the standard File::Copy module (also in Chapter 7 of Programming Perl); the rename, read, and syswrite functions in perlfunc (1) and in Chapter 3 of Programming Perl


Previous: 9.2. Deleting a FilePerl CookbookNext: 9.4. Recognizing Two Names for the Same File
9.2. Deleting a FileBook Index9.4. Recognizing Two Names for the Same File

Library Navigation Links

Copyright © 2001 O'Reilly & Associates. All rights reserved.